Table of Contents
Advertisement
Syslog Commands
78-20269-01 Command Line Interface Reference Guide
Example
To turn off aggregation of SYSLOG messages:
console(config)# no logging aggregation on
18.10 logging aggregation aging-time
Use the logging aggregation aging-time Global Configuration mode command to
configure the aging time of the aggregated SYSLOG messages. The SYSLOG
messages are aggregated during the time interval set by the aging-time
parameter. Use the no form of this command to return to the default.
Syntax
logging aggregation aging-time
no logging aggregation aging-time
Parameters
sec
aging-time
—Aging time in seconds (Range: 15–3600)
Default Configuration
300 seconds.
Command Mode
Global Configuration mode
Example
console(config)# logging aggregation aging-time 300
18.11 show logging
Use the show logging Privileged EXEC mode command to display the logging
status and SYSLOG messages stored in the internal buffer.
Syntax
show logging
sec
18
227
Advertisement
Table of Contents
