Cisco Small Business 300 1.1 Series Administration Manual page 351

Address Table Commands
78-20269-01 Command Line Interface Reference Guide
-
mac—Specifies that the multicast address is a MAC address.
•
source {ipv4-source-address | ipv6-source-address}—Specifies the source
address. The possible values are:
-
ipv4-address—Specifies the source IPv4 address.
-
ipv6-address—Specifies the source IPv6 address.
Default Configuration
If the format is not specified, it defaults to mac.
Command Mode
EXEC mode
User Guidelines
A MAC address can be displayed in IP format only if it is within the range
0100.5e00.0000 through 0100.5e7f.ffff.
Multicast Router ports (defined statically or discovered dynamically) are members
in all MC groups.
Ports that were defined via bridge multicast forbidden forward-all command are
displayed in all forbidden MC entries.
Changing the multicast mode can move static multicast addresses that are written
in the device FDB to a shadow configuration because of FDB hash collisions.
Example
The following example displays bridge multicast address information.
Console#
show bridge multicast address-table
Multicast address table for VLANs in MAC-GROUP bridging mode:
Vlan MAC Address
---- -----------------
8 01:00:5e:02:02:03
Forbidden ports for multicast addresses:
Vlan MAC Address
---- -----------------
Type Ports
-------------- -----
Static 1-2
Ports
-----
27
352