Cisco Small Business 300 1.1 Series Administration Manual page 74

System Management Commands
78-20269-01 Command Line Interface Reference Guide
•
hostname—Hostname of the destination host. (Range: 1–160 characters.
Maximum label size: 63)
•
packet_size
size
tag. The default is 64 bytes. (IPv4:64-1518, IPv6: 68-1518)
•
max-ttl
ttl —The largest TTL value that can be used. The default is 30. The
traceroute command terminates when the destination is reached or when
this value is reached. (Range: 1–255)
•
packet_count
count
The default count is 3. (Range: 1–10)
•
time_out
timeout
packet. The default is 3 seconds. (Range: 1–60)
•
ip-address
source
a source address for the probes. The device selects the optimal source
address by default. (Range: Valid IP address)
•
tos tos —The Type-Of-Service byte in the IP Header of the packet. (Range:
0–255)
Default Usage
N/A
Command Mode
EXEC mode
User Guidelines
The traceroute command works by taking advantage of the error messages
generated by routers when a datagram exceeds its time-to-live (TTL) value.
The traceroute command starts by sending probe datagrams with a TTL value of
one. This causes the first router to discard the probe datagram and send back an
error message. The traceroute command sends several probes at each TTL level
and displays the round-trip time for each.
The traceroute command sends out one probe at a time. Each outgoing packet can
result in one or two error messages. A "time exceeded" error message indicates
that an intermediate router has seen and discarded the probe. A "destination
unreachable" error message indicates that the destination node has received the
probe and discarded it because it could not deliver the packet. If the timer goes
off before a response comes in, the traceroute command prints an asterisk (*).
—Number of bytes in the packet not including the VLAN
—The number of probes to be sent at each TTL level.
—The number of seconds to wait for a response to a probe
—One of the interface addresses of the device to use as
5
75