Lldp Med Location - Cisco Small Business 300 1.1 Series Administration Manual

Link Layer Discovery Protocol (LLDP) Commands
78-20269-01 Command Line Interface Reference Guide

44.20 lldp med location

Use the lldp med location Interface Configuration (Ethernet) mode command to
configure the location information for the LLDP Media Endpoint Discovery (MED)
for a port. Use the no form of this command to delete location information for a
port.
Syntax
lldp med location {{coordinate data} | {civic-address data} | {ecs-elin data}}
no lldp med location
Parameters
•
data
coordinate
hexadecimal format.
•
civic-address
hexadecimal format.
•
data
ecs-elin —Specifies the location data as an Emergency Call Service
Emergency Location Identification Number (ECS ELIN) in hexadecimal
format.
•
data—Specifies the location data in the format defined in ANSI/TIA 1057:
dotted hexadecimal data: Each byte in a hexadecimal character string is
two hexadecimal digits. Bytes are separated by a period or colon. (Length:
coordinate: 16 bytes. Civic-address: 6-160 bytes. Ecs-elin: 10-25 bytes)
Default Configuration
The location is not configured.
Command Mode
Interface Configuration (Ethernet) mode
Example
The following example configures the LLDP MED location information on gi2 as a
civic address.
console(config)# interface gi2
console(config-if)# lldp med location civic-address 616263646566
{coordinate | civic-address | ecs-elin}
—Specifies the location data as coordinates in
data
—Specifies the location data as a civic address in
44
665