Smartport Switchport Trunk Native Vlan - Cisco Small Business 300 1.1 Series Administration Manual

Smartport Commands
78-20269-01 Command Line Interface Reference Guide
Command Mode
Interface Configuration (Ethernet, port-channel) mode
User Guidelines
This command is an extension of the switchport trunk allowed vlan command.
Unlike the switchport trunk allowed vlan command, the
command may include the voice VLAN (when it is the default VLAN). If the default
VLAN is the voice VLAN, the following occurs:
•
all
add — Adds the interface to the default VLAN as an egress tagged port.
•
all
remove — Removes the interface from the default VLAN.
Example
To add port 1 to VLANs 1-5:
console(conf)#interface gi1
console(conf-if)#smartport switchport trunk allowed vlan add 1-5

43.16 smartport switchport trunk native vlan

Use the smartport switchport trunk native vlan Interface Configuration (Ethernet,
port-channel) mode command to define the native VLAN when the interface is in
trunk mode. Use the no form of this command to restore the default configuration.
Syntax
smartport switchport trunk native vlan
Parameters
native-vlan-id—Specifies the native VLAN ID.
Default Configuration
VLAN 1
Command Mode
Interface Configuration (Ethernet, port-channel) mode
vlan-list
native vlan-id
-
43
parameter of this
646