Smartport Switchport Trunk Allowed Vlan - Cisco Small Business 300 1.1 Series Administration Manual

Smartport Commands
78-20269-01 Command Line Interface Reference Guide
console(config-if)#interface gi1
console(config-if)#macro auto smartport
console(config-if)#end
console#show macro auto ports gi1
SmartPort is Enabled
Administrative Globally Auto SmartPort is enabled
Operational Globally Auto SmartPort is enabled
Auto SmartPort is enabled on gi1
Persistent state is persistent
Interface type is switch
Last activated macro is switch

43.15 smartport switchport trunk allowed vlan

The smartport switchport trunk allowed vlan Interface Configuration (Ethernet,
port-channel) mode command adds/removes VLANs to/from a trunk port.
Syntax
smartport switchport trunk allowed vlan {add [
Parameters
vlan-list
add — Specifies a list of VLAN IDs to add to interface. Separate
nonconsecutive VLAN IDs with a comma and no spaces; use a hyphen to
designate a range of IDs.
all
add — Add all VLANs to interface.
vlan-list
remove — Specifies a list of VLAN IDs to remove. Separate
nonconsecutive VLAN IDs with a comma and no spaces; use a hyphen to
designate a range of IDs.
all
remove — Remove all VLANs from interface.
Default Configuration
N/A
vlan-list | all
] | remove [
43
vlan-list | all
]}
645