Table of Contents
Advertisement
Clock Commands
78-20269-01 Command Line Interface Reference Guide
Syntax
ipv4-address
sntp server {
keyid
]
ipv4-address
no sntp server {
Parameters
•
ipv4-address—Specifies the server IPv4 address.
•
ipv6-address—Specifies the server IPv6 address. A Link Local address
(IPv6Z address) can be defined.
•
—
pv6z-address
ipv6-link-local-address
format is:
are:
-
ipv6-link-local-address—Specifies the IPv6 Link Local address.
-
interface-name—Specifies the outgoing interface name. The interface
name has the format:
physical-port-name
{
decimal-digit
{
0–9)
The following combinations are possible:
-
ipv6_address%interface_id - Refers to the IPv6 address on the interface
specified.
-
ipv6_address%0 - Refers to the IPv6 address on the single interface on
which an IPv6 address is defined.
-
ipv6_address - Refers to the IPv6 address on the single interface on
which an IPv6 address is defined.
•
hostname—Specifies the server hostname. Only translation to IPv4
addresses is supported. (Length: 1–158 characters. Maximum label length:
63 characters)
•
poll—Enables polling.
•
key keyid—Specifies the Authentication key to use when sending packets
to this peer. (Range:1–4294967295)
Default Configuration
No servers are defined.
ipv6-address
ipv6z-address
|
|
ipv6-address
|
Specifies the IPv6Z address to ping. The IPv6Z address
interface-name
}%{
vlan
integer
{
}. The subparameter integer has the format:
integer
decimal-digit
} | {
}{
hostname
|
ipv6z-address
hostname
|
|
}. The subparameters
po
integer
isatap
} |
{
} |
}. (Range for the decimal-digit:
6
poll
key
} [
] [
}
integer
{
} |
108
Advertisement
Table of Contents
