Network Management Protocol (Snmp) Commands; Snmp-Server; Snmp-Server Community - Cisco Small Business 300 1.1 Series Administration Manual

Network Management Protocol (SNMP) Commands

10
Network Management Protocol (SNMP) Commands
78-20269-01 Command Line Interface Reference Guide
10.1

snmp-server

Use the snmp-server server Global Configuration mode command to enable the
device to be configured by SNMP. Use the no form of this command to disable this
function.
Syntax
snmp-server server
no snmp-server server
Parameters
N/A
Default Configuration
Enabled
Command Mode
Global Configuration mode
Example
console(config)# snmp-server server
10.2

snmp-server community

Use the snmp-server community Global Configuration mode command to set up
the community access string to permit access to the Simple Network
Management Protocol command. Use the no form of this command to remove the
specified community string.
Syntax
snmp-server community
ipv6-address} [mask | prefix-length] [type router]
snmp-server community-group
[mask | prefix-length] [type router]
string [ view-name] [ro | rw | su] {ipv4-address|
view
string group-name [ipv4-address| ipv6-address]
10
145