Configuring Lldp And Lldp-Med; Default Lldp Configuration - Cisco Catalyst 2360 Software Configuration Manual

Chapter 18

Configuring LLDP and LLDP-MED

•
Configuring LLDP and LLDP-MED
This section contains this configuration information:
•
•
•
•
•

Default LLDP Configuration

Table 18-1
configuration and LLDP interface configuration commands.
Table 18-1
Feature
LLDP global state
LLDP holdtime (before discarding)
LLDP timer (packet update frequency)
LLDP reinitialization delay
LLDP tlv-select
LLDP interface state
LLDP receive
LLDP transmit
LLDP med-tlv-select
OL-19808-01
Location TLV
Provides location information from the switch to the endpoint device. The location TLV can send
this information:
Civic location information
–
Provides the civic address information and postal information. Examples of civic location
information are street address, road name, and postal community name information.
– ELIN location information
Provides the location information of a caller. The location is determined by the Emergency
location identifier number (ELIN), which is a phone number that routes an emergency call to
the local public safety answering point (PSAP) and which the PSAP can use to call back the
emergency caller.
Default LLDP Configuration, page 18-3
Configuring LLDP Characteristics, page 18-4
Disabling and Enabling LLDP Globally, page 18-5
Disabling and Enabling LLDP on an Interface, page 18-5
Configuring LLDP-MED TLVs, page 18-6
shows the default LLDP configuration. To change the default settings, use the LLDP global
Default LLDP Configuration
Configuring LLDP and LLDP-MED
Default Setting
Disabled
120 seconds
30 seconds
2 seconds
Disabled to send and receive all TLVs.
Disabled
Disabled
Disabled
Disabled to send all LLDP-MED TLVs
Catalyst 2360 Switch Software Configuration Guide
18-3