Lacp Timeout - Cisco Small Business 300 1.1 Series Administration Manual

Link Aggregation Control Protocol (LACP) Commands
78-20269-01 Command Line Interface Reference Guide
Parameters
value—Specifies the port priority. (Range: 1use the no form of this
command65535)
Default Configuration
The default port priority is 1.
Command Mode
Interface Configuration (Ethernet) mode
Example
The following example sets the priority of gi6.
console(config)# interface
console(config-if)# lacp port-priority 247
33.3

lacp timeout

Use the lacp timeout Interface Configuration (Ethernet) mode command to assign
an administrative LACP timeout to an interface. Use the no form of this command
to restore the default configuration.
Syntax
{long | short}
lacp timeout
no lacp timeout
Parameters
•
long—Specifies the long timeout value.
•
short—Specifies the short timeout value.
Default Configuration
The default port timeout value is Long.
Command Mode
Interface Configuration (Ethernet) mode
gi
6
33
465