Ip Igmp Query-Interval - Cisco Small Business 300 1.1 Series Administration Manual

Internet Group Management Protocol (IGMP) Snooping Commands
78-20269-01 Command Line Interface Reference Guide
Syntax
count
ip igmp robustness
no ip igmp robustness
Parameters
count—The number of expected packet loss on a link. Parameter range. (Range:
1–7)
Default Configuration
2
Command Mode
Interface Configuration (VLAN) mode
User Guidelines
You can execute the command before the VLAN is created, but you must enter the
command in Interface VLAN mode.
Example
console(config)# interface vlan 1
console(config-if)# ip igmp robustness 3

31.11 ip igmp query-interval

Use the ip igmp query-interval Interface Configuration (VLAN) mode command to
configure the Query interval on a VLAN. Use the no format of the command to
return to default.
Syntax
ip igmp query-interval
no ip igmp query-interval
Parameters
seconds—Frequency, in seconds, at which IGMP query messages are sent on the
interface. (Range: 30–18000)
seconds
31
443