Bridge Multicast Forward-All - Cisco Small Business 300 1.1 Series Administration Manual

Address Table Commands
78-20269-01 Command Line Interface Reference Guide
You can execute the command before the VLAN is created.
Example
The following example specifies that unregistered multicast packets are filtered
on gi1:
Console(config)#
interface gi1
Console(config-if)#

27.15 bridge multicast forward-all

Use the bridge multicast forward-all Interface Configuration (VLAN) mode
command to enable forwarding all multicast packets for a range of ports or port
channels. Use the no form of this command to restore the default configuration.
Syntax
bridge multicast forward-all
port-channel-list}
no bridge multicast forward-all
Parameters
•
add—Forces forwarding of all multicast packets.
•
remove—Does not force forwarding of all multicast packets.
•
interface-list
ethernet
nonconsecutive Ethernet ports with a comma and no spaces. Use a hyphen
to designate a range of ports.
•
port-channel-list
port-channel
nonconsecutive port-channels with a comma and no spaces. Use a hyphen
to designate a range of port channels.
Default Configuration
Forwarding of all multicast packets is disabled.
Command Mode
Interface Configuration (VLAN) mode
bridge multicast unregistered filtering
{add | remove} {ethernet interface-list | port-channel
—Specifies a list of Ethernet ports. Separate
—Specifies a list of port channels. Separate
27
341