Processor And Heat Sink Replacement; Technician Only) - Lenovo ThinkSystem SD530 V3 User Manual

Step 2. Connect the cables between the power distribution board and system board (see
distribution board cable routing" on page
After this task is completed
1. Reinstall the power bus bar (see
2. If necessary, reinstall the PCIe riser assembly to the node and reconnect the required PCIe cables to the
system board (see "Install a PCIe riser assembly" on page 121
page 173).
3. If necessary, reinstall the GPU air duct (see
4. Make sure that all the required cables are routed and connected correctly; then, reinstall the top cover
(see "Install the top cover" on page
5. Reinstall the node into the chassis (see
6. Make sure that the required power supply units are installed and power cords are connected; then,
power on the node (see
51.)
7. Proceed to complete the parts replacement (see
Processor and heat sink replacement (trained technician only)
Follow instructions in this section to remove or install a processor and heat sink module (PHM).
Important: This task must be operated by trained technicians.
Attention: Before reusing a processor or heat sink, make sure to use Lenovo proven alcohol cleaning pad
and thermal grease.
Remove the processor and heat sink
This task has instructions for removing the assembled processor and heat sink, known as a processor-heat-
sink module (PHM). This task requires a Torx T30 driver. This procedure must be executed by a trained
technician.
Important: This task must be operated by trained technicians.
ThinkSystem SD530 V3 User Guide
130
179).
"Install a power bus bar" on page
"Install a GPU air duct" on page
170).
"Install a node to the chassis" on page
"Install a hot-swap power supply" on page 61
125).
and Chapter 6 "Internal cable routing" on
and
"Complete the parts replacement" on page
"Power
93).
75).
"Power on the node" on page
171).