Table of Contents
Advertisement
Inner Glass Panel Installation / Removal
Note: glass panels must be installed to operate fireplace
WARNING: GLASS HANDLING
We recommend using the glass vacuum holders supplied by the
manufacturer. Lower the glass to rest in a safe place to prevent
damage to the glass edges. Extra care must be taken when remov-
ing/installing the glass. Breakage or damage to the edge of the
glass which occurs as a result of careless handling is not covered
under warranty.
• We recommend handling the glass with the supplied vacuum
clamps.
• When removing the glass, prepare a soft, scratch-resistant
surface on which to place the 1554 mm x 504 mm glass.
• Never clean or remove hot glass.
Note: The suction cups may leave a round film on the glass
when used. Ensure that the glass is cleaned using a fireplace
glass cleaner after each removal and prior to operating the
appliance.
1. Remove outer safety barrier glass panels if previously installed–see instruc-
tions in this manual.
2. Remove outer panels installed in unit - see panel removal section in this manual.
Press glass vacuum clamps in open position firmly onto surface of glass.
Bring handles together to close.
Open
Handle glass with supplied vacuum clamps
Note--the following installation diagrams do not include the
vacuum clamps but it is strongly recommended to use
clamps at all times when handling the firebox glass.
Closed
Glass removal video
3. From the front inside lower panel of the unit--pivot the glass support into
upright position as shown below.
Glass supports in upright position
4. Open the 8 clamps at the top of the glass.
With the top clamps in open position, use your hands to pull the two glass
gasket rails towards you.
Clamps in closed position
owner's information
Clamps in open position, rail
pulled forward
City Series ACB60E | 19
Advertisement
Table of Contents
