Mitsubishi QD75P1N User Manual page 774

APPENDICES
QD75 READY (X0)
Synchronization flag (X1)
M code ON
Error detection
BUSY
Start complete
Positioning complete
PLC READY (Y0)
Axis stop
Forward JOG start
Reverse JOG start
Positioning start
Execution prohibition flag
External I/O signal lower limit
External I/O signal upper limit
External I/O signal drive unit ready
External I/O signal stop signal
External I/O signal external command
External I/O signal zero signal
External I/O signal near-point dog signal
External I/O signal deviation counter clear
External command valid
Status speed controlling flag
Status speed and position change latch flag
Status command in-position flag
Status OPR request flag
Status OPR complete flag
Status position and speed change latch flag
Status axis warning detection
Status speed change 0 flag
Turns green when the
signal is turned ON.
The status by each axis of the following items is displayed in the "Module Information
List" window.
Monitor item
Statuses turned ON are displayed in green by each axis.
Also, at error occurrence, the axis in which the error occurred ("Error detection") is
displayed in red.
At occurrence of warning, the axis in which the warning occurred ("Status axis warning
detection") is displayed in orange.
Device No. of the I/O signal device
or symbol of the buffer memory to
Axis 1
X4
X8
XC
X10
X14
Y4
Y8
Y9
Y10
Y14
Appendix - 88
be referred
Axis 2 Axis 3 Axis 4
X0
X1
X5 X6 X7
X9 XA XB
XD XE XF
X11 X12 X13
X15 X16 X17
Y0
Y5 Y6 Y7
YA YC YE
YB YD YF
Y11 Y12 Y13
Y15 Y16 Y17
Md.30
Cd.8
Md.31
MELSEC-Q
Reference
Section 3.3.2
Section 3.3.3
Section 5.6.2
Section 5.7.2
Section 5.6.2