Mitsubishi QD75P1N User Manual page 677

15 TROUBLESHOOTING
Related buffer memory
address
Axis 1 Axis 2 Axis 3 Axis 4
71 221 371 521
72 222 372 522
73 223 373 523
74 224 374 524
75 225 375 525
76 226 376 526
77 227 377 527
78 228 378 528
80 230 380 530
81 231 381 531
82 232 382 532
83 233 383 533
86 236 386 536
87 237 387 537
88 238 388 538
Set range
(Setting with sequence program)
0, 1
• [mm] [inch] [pulse]
–2147483648 to 2147483647
• [degree] 0 to 35999999
QD75P N/QD75D N:
1 to 4000000 [pulse/s]
1 to 2000000000
-2
[ × 10
mm/min or others]
QD75P /QD75D :
1 to 1000000 [pulse/s]
1 to 2000000000
-2
[ × 10
mm/min or others]
0, 1
0 to 2147483647
0, 1, 2, 3
0, 1, 2, 3
1 to 300
1 to 65535
0, 1
With the setting brought into the setting range, turn the
PLC READY signal [Y0] from OFF to ON.
• Bring the setting into the setting range.
• Set the speed to the bias speed at start or higher.
(Refer to Section 5.2.5)
• Bring the setting into the setting range.
• Set the speed to that below the OPR speed.
• Set the value to the bias speed at start or higher.
(Refer to Section 5.2.5)
With the setting brought into the setting range, turn the
PLC READY signal [Y0] from OFF to ON.
15 - 39
MELSEC-Q
Remedy