Mitsubishi QD75P1N User Manual page 523

12 CONTROL SUB FUNCTIONS
Setting item
Output timing
Cd.43
selection of near
pass control
Refer to Section 5.7 "List of control data" for setting details.
[3] Setting method
To use the function "output timing selection of near pass control", set the
following control data in a sequence program.
The set detail is validated at the rising edge (OFF
signal (Y0).
Setting
value
Select the timing to output the difference (
between the actual and the set positioning end
addresses in continuous path control, in which the
difference (
next positioning data.
Setting details
) is output during the execution of the
0: At constant speed
1: At deceleration
12 - 25
MELSEC-Q
ON) of the PLC READY
Buffer memory
address
)
1934