1 PRODUCT OUTLINE
Understand the product functions and usage methods, the configuration devices
1)
and specifications required for positioning control, and design the system.
Install the QD75 onto the base unit, wire the QD75 and external connection
2)
devices (drive unit, etc.).
Using GX Configurator-QP, set the parameters, positioning data, block start data
3)
and condition data required for the positioning control to be executed.
Using GX Developer, create the sequence program required for positioning
4)
operation. (When not using GX Configurator-QP, also create the sequence
program for setting data.)
Write the parameters and positioning data, etc., created with GX Configurator-QP
5)
into the QD75.
Using GX Developer, write the created sequence program into the CPU module.
6)
(When not using GX Configurator-QP, also write in the sequence program for
setting data.)
Carry out test operation and adjustments in the test mode to check the connection
with the QD75 and external connection device, and to confirm that the designated
7)
positioning operation is executed correctly. (Debug the set "parameters" and
"positioning data", etc.)
Carry out test operation and adjustment to confirm that the designated positioning
8)
operation is executed correctly. (Debug the created sequence program. When not
using GX Configurator-QP, also debug the set data.
Actually operate the positioning operation. At this time, monitor the operation state
9)
as required. If an error or warning occurs, remedy.
10) Service the QD75 as required.
11) Dispose of the QD75.
1: When setting the QD75P N/QD75D N using GX Configurator-QP, there are restrictions on the setting ranges of
some items. (Refer to Appendix 1.2.)
The following work is carried out with the processes shown on the previous page.
Details
1
1 - 16
MELSEC-Q
Reference
•
CHAPTER 1
•
CHAPTER 2
•
CHAPTER 3
•
CHAPTER 8 to CHAPTER 13
•
CHAPTER 4
•
CHAPTER 5
•
CHAPTER 8 to CHAPTER 13
•
GX Configurator-QP
Operating Manual
•
CHAPTER 6
•
GX Developer Operating
Manual
•
CHAPTER 7
•
GX Configurator-QP
Operating Manual
•
CHAPTER 7
•
GX Developer Operating
Manual
•
GX Configurator-QP
Operating Manual
•
CHAPTER 13
•
GX Developer Operating
Manual
•
GX Developer Operating
Manual
•
CHAPTER 5
•
CHAPTER 15
•
GX Configurator-QP
Operating Manual
•
GX Developer Operating
Manual
•
CHAPTER 4
•
CHAPTER 4