Mitsubishi QD75P1N User Manual page 291

PART 2 CONTROL DETAILS AND SETTING
PART 2 is configured for the following purposes (1) to (3).
(1) To understand the operation and restrictions of each control.
(2) To carry out the required settings in each control.
(3) To deal with errors.
The required settings in each control include parameter setting, positioning data setting,
control data setting by a sequence program, etc.
Carry out these settings while referring to CHAPTER 5 "DATA USED FOR POSITIONING
CONTROL".
Also refer to CHAPTER 6 "SEQUENCE PROGRAMS USED FOR POSITIONING
CONTROL" when creating the programs required in each control, and consider the entire
control program configuration when creating each program.
CHAPTER 8 OPR CONTROL .....................................................................................8- 1 to 8- 24
CHAPTER 9 MAJOR POSITIONING CONTROL..................................................... 9- 1 to 9-120
CHAPTER 10 HIGH-LEVEL POSITIONING CONTROL......................................... 10- 1 to 10- 28
CHAPTER 11 MANUAL CONTROL......................................................................... 11- 1 to 11- 34
CHAPTER 12 CONTROL SUB FUNCTIONS......................................................... 12- 1 to 12-104
CHAPTER 13 COMMON FUNCTIONS .................................................................... 13- 1 to 13- 8
CHAPTER 14 DEDICATED INSTRUCTIONS ......................................................... 14- 1 to 14- 24
CHAPTER 15 TROUBLESHOOTING ...................................................................... 15- 1 to 15- 48