1830 Cwdm Shelf Layout And Description; Figure 24: 1830 Cwdm Shelf Layout - Alcatel-Lucent 7210 SAS M Configuration Manual

System Basics Introduction
unsupported devices results in an error log being printed. A shelf created by the user will be
operationally down when an unrecognized device is plugged into the USB port. The user can
interchange the device connected to the USB port without requiring a reboot. For example, when
the 7210 SAS is operating with a clip-on device, the user can pull out the clip-on device, instead
plug-in a USB mass-storage device to copy over image files or other files, and then plug back a
clip-on device.

1830 CWDM shelf layout and description

NOTE: In the paragraph below, the 1830 shelf is shown as an illustration. For a definitive
information on 1830 device and support consult the 1830 product manuals.
The 1830 CWDM passive device appears as shown below.
The Slot#1 in the figure accepts only the controller card and is named using the acronym EC-CW
for 1830 CWDM device. The 7210 does not require provisioning of this card. This card type is
implicitly specified when user configures the 1830 VWM shelf type. Only if this card is present
and connected to the 7210, the 7210 provides inventory and equipment management capability. If
it is not present, this management functionality is lost. It is possible to operate the 1830 CWDM
device as a passive filter without the controller card in slot#1. It cannot be managed with the 7210.
Slot #2 and slot #3 can be equipped with supported CWDM filter cards. User must provision the
cards that will be populated in these slots. 7210 software checks and ensures that the equipped card
type matches the provisioned card type and logs an event if it does not match.
Page 246

Figure 24: 1830 CWDM shelf layout

7210 SAS M, T, X, R6 Basic System Configuration Guide