Alcatel-Lucent 7210 SAS M Configuration Manual page 494

System Commands
Page 494
Label
Chosen
ChosenPPS
Remote
Reference ID
St
7210 SAS M, T, X, R6 Basic System Configuration Guide
Description (Continued)
The peer is chosen as the source of synchronization.
The peer is chosen as the source of synchronization, but the actual syn-
chronization is occurring from a pulse-per-second (PPS) signal.
The IP address of the remote NTP server or peer with which this local
host is exchanging NTP packets.
When stratum is between 0 and 15 this field shows the IP address of
the remote NTP server or peer with which the remote is exchanging
NTP packets. For reference clocks, this field shows the identification
assigned to the clock, such as, ".GPS." For an NTP server or peer, if
the client has not yet synchronized to a server/peer, the status cannot be
determined and displays the following codes:
Peer Codes:
ACST — The association belongs to any cast server.
AUTH — Server authentication failed. Please wait while the associa-
tion is restarted.
AUTO — Autokey sequence failed. Please wait while the association
is restarted.
BCST — The association belongs to a broadcast server.
CRPT — Cryptographic authentication or identification failed. The
details should be in the system log file or the cryptostats statistics file,
if configured. No further messages will be sent to the server.
DENY — Access denied by remote server. No further messages will
be sent to the server.
DROP — Lost peer in symmetric mode. Please wait while the associa-
tion is restarted.
RSTR — Access denied due to local policy. No further messages will
be sent to the server.
INIT — The association has not yet synchronized for the first time.
MCST — The association belongs to a manycast server.
NKEY — No key found. Either the key was never installed or is not
trusted.
RATE — Rate exceeded. The server has temporarily denied access
because the client exceeded the rate threshold.
RMOT — The association from a remote host running ntpdc has had
unauthorized attempted access.
STEP — A step change in system time has occurred, but the associa-
tion has not yet resynchronized.
System Codes
INIT — The system clock has not yet synchronized for the first time.
STEP — A step change in system time has occurred, but the system
clock has not yet resynchronized.
Stratum level of this node.