Configuration Guidelines For System Resource Profile - Alcatel-Lucent 7210 SAS M Configuration Manual

System Basics Introduction
ipv6-64-bit criteria or the entire chunk is allocated to ipv6-64-bit criteria, if the first SAP that
needs resources requests for ipv6-64-bit criteria and there are no entries in the chunk already
allocated to ipv6-64-bit criteria, leaving no resources for use by mac-criteria.

Configuration Guidelines for System Resource Profile

The following configuration guidelines are applicable to 7210 SAS-R6:
•
•
•
Page 258
The user can change the system-resource policy attached to a card/IMM, in the following
cases:
→ When the card/IMM state is un-provisioned
→ When the card/IMM is provisioned but not equipped
→ When the card/IMM is provisioned and equipped, but there is a mismatch between the
two
On provisioning the card, subsequent to attaching a new system-resource policy, the
parameters specified in the policy are used (including any boot-time parameters).
If the card is provisioned and equipped, and if the user changes any boot-time parameter in
the system-resource policy, the user needs to issue the card reset command for all the cards
which are using the policy or reboot the chassis, for it to take effect.
7210 SAS M, T, X, R6 Basic System Configuration Guide