Alcatel-Lucent 7210 SAS M Configuration Manual page 493

Context show>system
Description This command displays NTP protocol configuration and state.
Output Show NTP Output — The following table describes NTP output fields.
7210 SAS M, T, X, R6 Basic System Configuration Guide
Label
Enabled
Admin Status
NTP Server
Stratum
Oper Status
Auth Check
System Ref. ID
Auth Error
Auth Errors
Ignored
Auth key ID Errors
Auth Key Type
Errors
Reject
Invalid
Excess
Outlyer
Candidate
Selected
— NTP is enabled.
yes
— NTP is disabled.
no
— Administrative state is enabled.
yes
— Administrative state is disabled.
no
Displays NTP server state of this node.
Displays stratum level of this node.
— The operational state is enabled.
yes
— The operational state is disabled.
no
Displays the authentication requirement
IP address of this node or a 4-character ASCII code showing the state.
Displays the number of authentication errors.
Displays the number of authentication errors ignored.
Displays the number of key identification errors .
Displays the number of authentication key type errors.
The peer is rejected and will not be used for synchronization. Rejection
reasons could be the peer is unreachable, the peer is synchronized to
this local server so synchronizing with it would create a sync loop, or
the synchronization distance is too large. This is the normal startup
state.
The peer is not maintaining an accurate clock. This peer will not be
used for synchronization.
The peer's synchronization distance is greater than ten other peers.
This peer will not be used for synchronization.
The peer is discarded as an outlyer. This peer will not be used for syn-
chronization.
The peer is accepted as a possible source of synchronization.
The peer is an acceptable source of synchronization, but its synchroni-
zation distance is greater than six other peers.
System Management
Description
Page 493