Alcatel-Lucent 7210 SAS M Configuration Manual page 183

Default
eth-mgmt-autoneg — Auto-negotiation is enabled on the management Ethernet port.
eth-mgmt-disabled
Syntax [no] eth-mgmt-disabled
Context bof
Description This command allows the user to enable or disable the out-of-band management Ethernet port for use
during boot up.
The no form of the command enables the port.
Default
eth-mgmt-disabled
eth-mgmt-duplex
Syntax eth-mgmt-duplex {full | half}
Context bof
Description This command configures the duplex mode of the management Ethernet port when Auto-negotiation
is disabled in the running configuration and the Boot Option File (BOF).
This configuration command allows for the configuration of the duplex mode of the Ethernet port. If
the port is configured to Auto-negotiate, this parameter will be ignored.
Default
eth-mgmt-duplex full — Full duplex operation.
Parameters full — Sets the link to full duplex mode.
half — Sets the link to half duplex mode.
eth-mgmt-route
Syntax [no] eth-mgmt-route ip-prefix/ip-prefix-length next-hop ip-address
Context bof
Description
This command creates a static route entry for the management Ethernet port in the running
configuration and the Boot Option File (BOF).
This command allows manual configuration of static routing table entries. These static routes are only
used by traffic generated by the Ethernet port. To reduce configuration, manual address aggregation
should be applied where possible.
A static default (0.0.0.0 or 0) route cannot be configured on the management Ethernet port. A
maximum of ten static routes can be configured on the management Ethernet port.
The no form of the command deletes the static route.
7210 SAS M, T, X, R6 Basic System Configuration Guide
Boot Option Files
Page 183