Alcatel-Lucent 7210 SAS M Configuration Manual page 373

priority1
Syntax [no] priority1 priority
Context config>system>ptp
This command configures the priority1 value of the local clock. This parameter is only used when the
profile is set to ieee1588-2008. This value is used by the Best Master Clock Algorithm to determine
which clock should provide timing for the network.
Note: This value is used both for the value to advertise in the Announce messages and for the local
clock value in data set comparisons. The no form of the command reverts to the default
configuration.
The no form of the command reverts to the default configuration.
Default
128
Parameters
priority — Specifies the value of the priority1 field.
7210 SAS M, T, X, R6 Basic System Configuration Guide
Values
0-255
System Management
Page 373