Alcatel-Lucent 7210 SAS M Configuration Manual page 93

Note: For more information about use of storage locations on 7210 SAS-R6 when using redundant
CPM configuration, see
on 7210 SAS-R6 on page
7210 SAS M, T, X, R6 Basic System Configuration Guide
are located at the same location as the default configuration file. The default configuration
file is created at the same place as the Timos image with which the system booted up.
For example - If the no configuration file location was specified in the BOF and the Timos
image (both.tim) located in uf1:\ was used to boot the system, then the default
configuration file, the index file, the sdx file and nvsys.info file will be created on uf1:\
and used subsequently. If the user specified the location of the configuration file in the
BOF as cf2:\, then the configuration file, the index file, the sdx file and nvsys.info file is
created on cf2:\ and used subsequently.
Configuration Guidelines for synchronization of active and standby CPM
216.
File System Management
Page 93