Alcatel-Lucent 7210 SAS M Configuration Manual page 474

Global System Resource Profile Commands for 7210 SAS-R6
When port-scheduler-mode is disabled, per SAP egress queues are available for use. Please see the
QoS user guide for more details on the two modes.
Enabling or Disabling port-scheduler-mode requires a reboot of the node.
Default
no port-scheduler-mode
qos-sap-egress-resource
Syntax no qos-sap-egress-resource
qos-sap-egress-resource
Context config>system>res-prof>ing-internal-tcam#
Description
Platforms Supported: 7210 SAS-R6.
This command can be used to allocate resources for SAP based egress queuing. If port-based queuing
is disabled, then users must allocate resources for SAP based egress queuing using this command. If
no resources are allocated then software will fail the creation of SAPs.
When port-based queuing is enabled, then resources can be taken away from SAP based egress
queues and allocated towards other features that share the ingress-internl-tcam pool (For example:
SAP ingress qos, Ingress ACLs).
Default
def
Parameters
num-resources — Specifies the amount of resources that are allocated towards SAP-based egress
queues.
sf-ingress-internal-tcam
Syntax sf-ingress-internal-tcam
Context config>system>glob-res-profile
Description
Platforms Supported: 7210 SAS-R6.
This command provides the context to configure the CAM resources available in the SF/CPM.
eth-cfm-upmeps
Page 474
Guide
Values
[0..2|def]
7210 SAS M, T, X, R6 Basic System Configuration