Alcatel-Lucent 7210 SAS M Configuration Manual page 180

File Management Commands
NOTES:
________________________________________________________________________________
Parameters
ip-address — The IP address of the Boot Option File (BOF). This address must be unique within the
mask — The subnet mask length when the IP prefix is specified in CIDR notation. When the IP prefix
uplinkA-port
Syntax uplinkA-port port-id
no uplinkA-port
Context bof
Description
This command configures the primary port to be used for boot up.
The no form of the command removes all the uplinkA parameters from the BOF.
________________________________________________________________________________
NOTE: This command is not supported on 7210 SAS-R6 platforms.
________________________________________________________________________________
Parameters port-id — Specifies the primary port to be used for boot up in the slot/mda/port format.
uplinkB-port
Syntax uplinkB-port port-id
no uplinkB-port
Context bof
Description
This command configures the secondary port to be used for boot up.
The no form of the command removes all the uplinkB parameters from the BOF.
________________________________________________________________________________
NOTE: This command is not supported on 7210 SAS-R6 platforms.
Page 180
• This command is not supported on 7210 SAS-R6 platforms.
• 7210 SAS-T does not support use of IPv6 addresses.
subnet and specified in dotted decimal notation.
Values a.b.c.d
is specified in CIDR notation, a forward slash (/) separates the ip-addr from the mask-length
parameter. The mask length parameter indicates the number of bits used for the network portion
of the IP address; the remainder of the IP address is used to determine the host portion of the IP
address.
Values
1 — 30
7210 SAS M, T, X, R6 Basic System Configuration