Alcatel-Lucent 7210 SAS M Configuration Manual page 349

Parameters
name — Specifies the operational group identifier up to 32 characters in length.
create — This keyword is required when first creating the configuration context. Once the context is
hold-time
Syntax hold-time
Context config>system>oper-group
Description
This command enables the context to configure hold time information.
group-down
Syntax [no] group-down time in seconds
Context config>system>oper-group>hold-time
Description
This command configures the number of seconds to wait before notifying clients monitoring this
group when its operational status transitions from down to up. A value of zero indicates that
transitions are reported immediately to monitoring clients.
The no form sets the values back to the defaults.
Default
0
Parameters time in seconds —
group-up
Syntax [no] group-up time in seconds
Context config>system>oper-group>hold-time
Description
This command configures the number of seconds to wait before notifying clients monitoring this
group when its operational status transitions from up to down.
The no form sets the values back to the default.
Default
4
Parameters time in seconds —
7210 SAS M, T, X, R6 Basic System Configuration Guide
Values
[32 chars max]
created, it is possible to navigate into the context without the create keyword.
Values Keyword
Values [0..3600]
Values [0..3600]
System Management
Page 349