Searching For The Bof - Alcatel-Lucent 7210 SAS M Configuration Manual

Common Configuration Tasks

Searching for the BOF

The BOF should be on the same drive as the bootstrap image file. If the system cannot load or
cannot find the
else continues with the auto-init mode. The system prompts for a different image and
configuration location.
NOTE: Auto-init is not supported on 7210 SAS-R6. The user must use the starter BOF or create a
BOF manually to boot the system.
The following example displays an example of the output when the boot sequence is interrupted
on 7210 SAS-M/X/T devices .
Hit a key within 3 seconds to change boot parameters...
Enter password to edit the Boot Options File
Or CTRL-D to exit the prompt
You must supply some required Boot Options. At any prompt, you can type:
"restart" - restart the query mode.
"reboot"
"exit"
"reset"
Press ENTER to begin, or 'flash' to enter firmware update, or the shell password...
Software Location
-----------------
You must enter the URL of the TiMOS software.
The location can be on a Compact Flash device,
or on the network.
Here are some examples
cf1:/timos1.0R1
ftp://user:passwd@192.168.1.150/./timos1.0R1
ftp://user:passwd@[3FFE::1]/./timos1.0R1
tftp://192.168.1.150/./timos1.0R1
tftp://3FFE::1/./timos1.0R1
The existing Image URL is 'ftp://*:*@10.10.170.22//home/***/images/both.tim'
Press ENTER to keep it.
Software Image URL:
Using: 'ftp://*:*@10.10.170.22//home/****/images/both.tim'
Configuration File Location
---------------------------
You must enter the location of configuration
file to be used by TiMOS.
a Compact Flash device, or on the network.
Page 150
, then the system checks whether the boot sequence was manually interrupted
BOF
- reboot.
- boot with with existing values.
- reset the bof and reboot.
The file can be on
7210 SAS M, T, X, R6 Basic System Configuration Guide