Yamaha RCX222 User Manual page 273

■ Network setting (2)
SYSTEM>PARAM>OP.BRD>SELECT
1.board condition
2.IP address
3.Subnet mask
4.gateway
5.port No
EDIT JUMP
2) Select the parameter with the cursor ( ↑ / ↓ ) keys.
c
CAUTION
Changes you made to the IP address, subnet mask and gateway are
enabled after restarting the robot controller. When connecting the robot
controller to an existing network, always consult with the network
administrator for the IP address, subnet mask and gateway settings.
■ Network setting (3)
SYSTEM>PARAM>OP.BRD>SELECT
1.board condition
2.IP address
3.Subnet mask
4.gateway
5.port No
EDIT JUMP
3) The currently set parameters are displayed.
When changing the "Board condition" parameter, press
the Ethernet unit or press
When changing the communication mode, press
mode or press
When changing other parameters, use
press .
4) Press to quit the edit mode.
V9.00
VALID
192.168.
255.255.255. 0
192.168.
23
V9.00
VALID
192.168.
255.255.255. 0
192.168.
23
(VALID) to enable the Ethernet unit.
(ONLINE) to set the online mode.
12. "SYSTEM" mode
0. 2
0. 1
0. 2
0. 1
(INVALID) to disable
(OFFLINE) to set the offline
to and to make the setting and
Chapter
4
4-203