Table of Contents
Advertisement
Section 3 • Scheduled Maintenance Procedures
CHECKLIST E PROCEDURES
8 Support and secure the hydraulic tank to a
suitable lifting device. Remove the hydraulic
tank from the machine.
9 Remove the suction strainers and clean them
using a mild solvent.
10 Rinse out the inside of the tank using a mild
solvent.
11 Install the suction strainers using a pipe thread
sealant on the threads.
12 Install the drain plug into the tank using a pipe
thread sealant on the threads.
13 Install the hydraulic tank on to the machine.
Install the hydraulic tank hold down straps and
tighten the retaining fasteners.
14 Fill the tank with hydraulic oil until the fluid until
the fluid is within the top 2 inches / 5.1 cm of
the sight gauge. Do not overfill.
15 Before serial number 3364: Open the two
hydraulic tank shut-off valves at the hydraulic
tank.
Component damage hazard. The
engine must not be started with
the hydraulic tank shut-off valves
in the closed position or
component damage will occur. If
the tank valves are closed,
remove the key from the key
switch and tag the machine to
inform personnel of the condition.
open
16 Clean up any oil that may have spilled. Properly
discard of oil.
17 Start the engine and check for leaks.
3 - 46
E-2
Grease the Steer Axle
Wheel Bearings, 2WD Models
Note: Genie requires that this procedure be
performed every 2000 hours or every two years,
whichever comes first.
Maintaining the steer axle wheel bearings is
essential for safe machine operation and service
life. Operating the machine with loose or worn
wheel bearings may cause an unsafe operating
condition and continued use may result in
component damage. Extremely wet or dirty
conditions or regular steam cleaning and pressure
washing of the machine may require that this
procedure be performed more often.
1 Loosen the wheel lug nuts. Do not remove
2 Block the non-steer wheels and center a lifting
3 Raise the machine 6 inches / 15 cm and place
4 Remove the lug nuts. Remove the tire and
5 Check for wheel bearing wear by attempting to
Skip to step 10 if there is no movement.
closed
Z-34/22 IC
them.
jack of ample capacity under the steer axle.
blocks under the drive chassis for support.
Crushing damage. The machine
may fall if not properly supported.
wheel assembly.
move the wheel hub side to side, then up and
down.
Result: There should be no side to side or up
and down movement.
July 2007
REV A
Part No. 128267
Advertisement
Table of Contents
