Perkins 404F-22T Engine Specifications - Genie Z-80/60 Service And Repair Manual

Service and Repair Manual
Specifications
Perkins 404F-22T
Displacement
Number of cylinders
Bore and Stroke
Horsepower net
intermittent @ 2800 rpm
Induction system
Firing order
Standy idle
Low idle
High idle
Compression ratio
Compression pressure pressure (psi or bar) of the
lowest cylinder must be at least 75% of the highest
cylinder
Governor
Valve Clearance, cold
Intake
Exhaust
Lubrication system
Oil pressure, hot (@ 2000 rpm)
Oil capacity (including filter)
Oil viscosity requirements
-22°F to 86°F / -30°C to 30°C
-4°F to 104°F / -20°C to 40°C
Above 5°F / -15°C
Unit ships with 15W-40.
Extreme operating temperatures may require the use of
alternative engine oils. For oil requirements, refer to the
Engine Operator Manual for your engine.
10
Oil Pressure switch
Installation torque
134 cu. in
2.2 liters
Pressure switch point
4
3.31 x 3.94 inches
Fuel injection system
84 x 100 mm
Injection pump make
55 hp
Injection pressure
41.1 kW
turbocharged
Fuel requirement
1 - 3 - 4 - 2
For fuel requirements, refer to the engine Operator
1100 rpm
Manual for your engine.
1500 rpm
Starter motor
2500 rpm
Current draw, normal load
23.3:1 Brush length, new
Brush length, minimum
Battery
electronic
Type
Quantity
0.008 in
0.2 mm
Battery capacity, maximum
0.018 in
Reserve capacity @ 25A rate
0.45 mm
Engine coolant
Capacity
40 to 60 psi
2.8 to 4.1 bar
Coolant temperature switch
9.4 - 11.2 quarts
Installation torque
8.9 - 10.6 liters
Temperature switch point
5W-20 CJ4
10W-40 CJ4
15W-40 CJ4
September 2016
8 - 18 ft-lbs
11 - 24 Nm
14.2 psi
1 bar
Zexel
2133 psi
147 bar
140A - 200A
0.7480 in
199 mm
0.5 in
12.7 mm
12V DC, Group 31
2
1000A
200 Minutes
14 quarts
13.3 liters
8 - 18 ft-lbs
11 - 24 Nm
221°F
105°C
Part No. 1268556