How To Adjust The Function Speeds - Genie Z-80/60 Service And Repair Manual

September 2016
15 Once the function speeds have been set,
press and hold the engine start button until the
engine shuts off. Do not press the red
Emergency Stop button.
Note: Approximately 3 seconds after the engine
shuts off, the alarm at the ground controls will
sound to indicate the settings are being saved in
memory.
16 At the ground controls, turn the key switch to
the off position, wait a moment and then turn
the key switch to platform controls.
17 Check the display at the ground controls to be
sure there are no calibration faults.
Note: There should be no calibration faults shown
on the display. If calibration faults exist, repeat this
procedure.
Part No. 1268556
Platform Controls
How to Adj ust the Functi on Speeds
How to Adjust the Function
Speeds
Note: Perform this procedure with the boom in the
stowed position.
Note: Use the following chart to identify the
description of each LCD screen control button used
in this procedure.
Plus Minus
1 Pull out the red Emergency Stop button to the
on position at both the ground and platform
controls.
2 Press and hold the enter button on the ground
control panel while turning the key switch to
platform controls. Hold the enter button for
approximately 5 seconds.
3 Press the plus button twice, then press the
minus button twice.
4 Press the previous button until the function to
be adjusted is displayed.
5 Press the plus button to increase the speed or
press the minus button to decrease the speed.
Service and Repair Manual
Previous Enter
27