Service and Repair Manual
Ground Controls
6-1
Bypass/Recovery Key Switch
The ground control box contains two key switches.
The main key switch towards the top of the control
box is for selection of ground or platform controls.
The key switch at the bottom of the control box is
the Bypass/Recovery key switch. Bypass and
Recovery modes are only intended for certain
circumstances and are not part of normal machine
operation. If either the Bypass or the Recovery
function is required, this indicates there may be
faults with the machine. Contact trained personnel
immediately.
Bypass is used for a platform out-of-envelope
condition and certain service situations.
Recovery is only to be used as a last attempt to
lower the platform when the operator in the platform
is unable to do so, system failure or in emergency
situations.
66
1 Run
2 Bypass
3 Recovery
September 2016
Part No. 1268556