Genie Z-80/60 Service And Repair Manual page 141

September 2016
Error Source
Motor Valve Speed
Brake Valve
Auxiliary Propel Valve
Platform Level Up/Down and
Rotate Valves
Platform Rotate Switches
Jib Boom Switches
Jib Boom Up/Down Valves
Steer Angle Sensor(s)
Right Front
Left Front
Right Rear
Left Rear
Turntable Level Sensor
X-Direction
Turntable Level Sensor
Y-Direction
Platform Level Sensor
Y-Direction
Footswitch Timeout
CAN Bus
Oil Pressure
Water/Oil Temperature
Oil Pressure Sender
Water/Oil Temp Sender
Engine Speed
Part No. 1268556
Error Type
Fault Check
Limited Speed and Direction frozen at
zero and neutral, Alarm sounds
Fault Check Fault Check
Fault Check Limited Speed and Direction frozen at
zero and neutral, Alarm sounds
Fault Check, (both Affected functions disabled, display
contacts closed) message on LCD.
Fault Check, (both Affected functions disabled, display
contacts closed) message on LCD.
Fault Check Limited Speed and Direction frozen at
zero and neutral, Alarm sounds
Value at 5.0 V
Limited Speed and Direction frozen at
zero and neutral, Alarm sounds
Value Too High
Value Too Low
Value at 0 V
Fault Check
Display message on LCD and sound
audible alarm.
Calibration check Display message on LCD
Fault Check Display message on LCD
Range Check (low Display message on LCD
oil pressure)
Range Check Display message on LCD
(high temp)
Fault Check Display message on LCD
Range Check Display message on LCD
(underspeed)
Control System Fault Codes
Effects
Check for defective or damaged
wiring. Check for an open or shorted
valve coil. Repair or replace as
necessary.
Check for defective or damaged wiring.
Check for an open or shorted valve coil.
Repair or replace as necessary.
Power up controller with problem
corrected.
Power up controller with problem
corrected.
Power up controller with problem
corrected.
Power up controller with problem
corrected.
Power up controller with problem
corrected.
Correct problem.
Recycle power
Power up controller with problem
corrected.
Oil pressure is low. Check sender and
oil level.
Engine is overheating. Check sender,
water or oil level or radiator/heat
exchanger.
Check wiring to senders for opens or
shorts. Repair or replace senders.
Power up controller with problem
corrected.
Service and Repair Manual
Recovery Actions
129