How To Adjust A Steer Sensor - Genie Z-80/60 Service And Repair Manual

Service and Repair Manual
Axle Components
How to Adj ust a Steer Sens or

How to Adjust a Steer Sensor

1 Start the engine from the platform controls.
2 Press down the foot switch and push the
engine idle select button until the engine
switches to high rpm.
Square-end steer sensors:
3 At the platform controls, press the circle-end
steer mode button.
4 Locate the steer sensor on top of the yoke
pivot pin.
5 Loosen the steer sensor cover retaining
fasteners. Do not remove them.
6 Rotate the steer sensor cover either clockwise
or counterclockwise. Measure the distance
between the inside of tire and the chassis side
plate on both sides of the axle.
Square-end Measure here
7 Repeat step 4 until the tire is parallel with the
chassis.
8 Tighten the steer sensor cover fasteners.
9 Repeat steps 2 through 6 for the other
square-end steer sensor.
118
Circle-end steer sensors:
10 At the platform controls, press the square-end
steer mode button.
11 Locate the steer sensor on top of the yoke
pivot pin.
12 Loosen the steer sensor cover retaining
fasteners. Do not remove them.
13 Rotate the steer sensor cover either clockwise
or counterclockwise. Measure the distance
between the inside of tire and the chassis side
plate on both sides of the axle.
14 Repeat step 4 until the tire is parallel with the
chassis.
15 Tighten the steer sensor cover fasteners.
16 Repeat steps 9 through 13 for the other
circle-end steer sensor.
17 At the platform controls, press the four-wheel
Circle-end
steer mode button. Measure the distance
between the inside of the tire and the chassis
side plate on both sides of the axle on each
tire.
18 If any tire is not parallel, repeat the process
beginning with step 3.
September 2016
Part No. 1268556