Routing Group Categories; Table 6: Fire Reports - Bosch D7212GV3 Program Entry Manual

D7212GV3 | Program Entry Guide | 2.0
Refer to Section 6.6 Programming Path Numbers and
IP Addresses for Enhanced Communications on
page 117 to enable enhanced communication paths.
Keypad Programming of R# Backup Device
D1255
1. Refer to Figure 1 on page 6 to access Keypad
Programming and navigate to the
ROUTE GRP 1 - 4 option.
2. At the ROUTE GRP 1 - 4 prompt, enter the route
group number you wish to configure and press
[ENT]. The keypad reads RT GRP 1 PRIMARY,
and then the current configuration (for example,
SDI 88 PATH 4).
3. Press [NEXT] to advance to the RT GRP 1
BACKUP option. The Primary device cannot be
set to No Device before setting the Backup
Destination.
4. To change the configuration, press [ENT] when
the current configuration shows, and then press
[NEXT] or [PREV] to scroll through the options,
as listed in R# Backup Device on page 15.
5. When the keypad reads the desired configuration
option, press [ENT] to select it.
6. When the keypad reads Parameter Saved, your
selection has been configured.
D1260
1. Refer to Figure 2 on page 7 to access Keypad
Programming and navigate to the
Route Group 1 - 4 option.
2. At the Route Group 1 - 4 prompt, enter the route
group number you wish to configure and press
[ENT]. The keypad reads Rt Group 1 Primary,
and then the current configuration (for example,
SDI 88 PATH 4).
3. Press the Backup softkey. The keypad reads Rt
Group 1 Primary, and then the current
configuration (for example, SDI 88 PATH 4). The
Primary device cannot be set to No Device
before setting the Backup Destination.
4. To change the configuration, press the Edit
softkey, and then press the Next or the Previous
softkey to scroll through the options, as listed in
R# Primary Device on page 14.
5. When the keypad reads the desired configuration
option, press the Save softkey to select it.
When the keypad reads Parameter Saved, your
selection has been configured.
Bosch Security Systems, Inc. | 10/11 | F01U170808-02
Panel and Area Wide Parameters
2.3.9

Routing Group Categories

Fire Reports
Selecting Yes enables a report to be sent when the
event occurs.

Table 6: Fire Reports

Report
R# Fire Alarm
R# Fire
Restore
(Alarm)
R# Fire
Missing
R# Fire
Trouble
R# Fire
Supervis
R# Fire
Restore
(T/M/S)
R# Fire
Cancel
R# Fire Sup
Miss
R# Fire Supv
Rest
Selection Report Description
s
Yes, No Fire Event
Yes, No Fire restoral from
alarm
Yes, No Missing Fire point
Yes, No Fire trouble
Yes, No Fire supervision
Yes, No Fire restoral from
trouble, missing, or
bypass
Yes, No Canceled fire alarm
Yes, No Fire supervisory
missing
Yes, No Restorals from Fire
Supervision
EN | 16