Message Prioritization Within A Route Number; Communication Attempts - Bosch D7212GV3 Program Entry Manual

D7212GV3 | Program Entry Guide | 2.0
2.3.7 Message Prioritization within a Route
Number
The D7212GV3 Control Panel meets the digital
reporting requirements for UL 864. Fire Alarm Events
have the highest priority and reports are sent first for
each group. Other events are sent in the following
order: Panic, Duress, Medical, Intrusion Alarm,
Supervisory, and all troubles and restorals.
2.3.8

Communication Attempts

The control panel makes up to ten communication
attempts using the primary and backup devices within
a route group. If unsuccessful, it sends a Comm Fail
Report. The communication attempts occur in the
following sequence:
Primary device
Primary device
Backup device
Backup device
Primary device
Backup device
Primary device
Backup device
Primary device
Backup device
There are four Route Groups which contain a
selection of event categorizes and individual events.
Each group has a primary and a backup device. The
primary device is the first (most important) destination
used to reach the programmed route within this
group. The backup device is used if the primary
device fails.
Bosch Security Systems, Inc. | 10/11 | F01U170808-02
Panel and Area Wide Parameters
R# Primary Device
Default:
Selection:
No Device
Phone 1
Phone 2
Phone 3
Phone 4
SDI 88
Path 1
SDI 88
Path 2
SDI 88
Path 3
SDI 88
Path 4
SDI 92
Path 1
SDI 92
Path 2
SDI 92
Path 3
SDI 92
Path 4
Select the communication device and the primary
destination.
Refer to Section 6.6 Programming Path Numbers and
IP Addresses for Enhanced Communications on
page 117 to enable enhanced communication paths.
Keypad Programming of R# Primary Device
D1255
1. Refer to Figure 1 on page 6 to access Keypad
Programming and navigate to the
ROUTE GRP 1 - 4 option.
2. At the ROUTE GRP 1 - 4 prompt, enter the route
group number you wish to configure and press
[ENT]. The keypad reads RT GRP 1 PRIMARY,
and then the current configuration (for example,
SDI 88 PATH 4).
No Device
No Device, Phone 1..4, SDI ##
Path 1..4
This route group is disabled.
Phone 1 is this group's primary
destination.
Phone 2 is this group's primary
destination.
Phone 3 is this group's primary
destination.
Phone 4 is this group's primary
destination.
Path 1 on SDI 88 is this group's
primary destination.
Path 2 on SDI 88 is this group's
primary destination.
Path 3 on SDI 88 is this group's
primary destination.
Path 4 on SDI 88 is this group's
primary destination.
Path 1 on SDI 92 is this group's
primary destination.
Path 2 on SDI 92 is this group's
primary destination.
Path 3 on SDI 92 is this group's
primary destination.
Path 4 on SDI 92 is this group's
primary destination.
EN | 14