Bypassing/Un-Bypassing The Output To Fault Warning Routing Equipment; Bypassing The Output To Fault Warning Routing Equipment; Un-Bypassing The Output To Fault Warning Routing Equipment - Bosch FPA‑5000 User Manual

52 en | Bypass
Caution!
If you switch the internal buzzer off permanently, no acoustic signal will sound on the panel in
!
the event of an alarm or fault!
11.6 Bypassing/Un-bypassing the output to fault warning routing
equipment
In the FSP-5000-RPS configuration the fault relay of the ENO 0000 A - Fire Service Interface
Module is configured as output to fault warning routing equipment according to EN54-2.
Note: To display and bypass/un-bypass the output to fault warning routing equipment, you
have to know the address (Group and Sub Address) and the label, which have been assigned
to the fault relay in the FSP-5000-RPS configuration.
11.6.1

Bypassing the output to fault warning routing equipment

To bypass the output to fault warning routing equipment, select the following in the start
menu:
1.
2.
3.
4.
5.
11.6.2

Un-bypassing the output to fault warning routing equipment

There are two ways to un-bypass the output to fault warning routing equipment:
–
–
Un-bypassing using the start menu
To un-bypass the output to fault warning routing equipment using the start menu, select the
following:
1.
2.
3.
4.
Un-bypassing via the status bar
To un-bypass the output to fault warning routing equipment via the status bar, select the
following:
1.
2.
2020-07 | 3.0 | F.01U.378.877
Bypass Block.
Bypass.
Select by number.
Enter the address (Group and Sub Address) that has been assigned to the fault relay in
the FSP-5000-RPS configuration and press the Enter key
A list of various states is displayed.
Select the output to fault warning routing equipment from the list and press Bypass.
If necessary, enter your user ID and password to log on to the panel controller.
The output to fault warning routing equipment is bypassed.
Un-bypassing using the start menu
Un-bypassing via the status bar
Bypass Block.
Bypass.
Show bypassed devices.
A list of various element categories is displayed.
Select the output to fault warning routing equipment from the list and press Un- bypass.
If necessary, enter your user ID and password to log on to the panel controller.
The output to fault warning routing equipment is un-bypassed.
Bypass.
A list of various states is displayed.
Show bypassed devices.
A list of various element categories is displayed.
User Guide
FPA-5000 | FPA-1200 | AVENAR panel 8000 |
AVENAR panel 2000 | AVENAR keypad 8000
.
Bosch Sicherheitssysteme GmbH