Miscellaneous - Bosch D7212GV3 Program Entry Manual

D7212GV3 | Program Entry Guide | 6.0
In the above example, if there is a
Communication Trouble Condition on the
DX4020, then the ITS-DX4020-G will poll
at the configured poll rate of the DX4020.
If the poll rate of the DX4020 is set to 5
minutes or faster, there is a possibility of
excessive data usage that may exceed
your data plan with the cellular service
provider. Be sure that any
Communication Trouble events are
addressed as soon as possible.
Bosch Security Systems, Inc. | 10/11 | F01U170808-02
AUXPARM
6.9

Miscellaneous

Fire Summary Sustain
Default:
Selection:
Yes
No
Use this parameter to set the Summary Fire relay
output to continue or to stop after the Fire Alarm Bell
is silenced or times out. Refer to the Summary Fire
prompt in Section 2.12.2 Panel-Wide Relays on page
72.
Fire Supervision Restoral Type
Default:
Selection:
0
1
2
Determines how the control panel sends a Fire
Supervision Restoral Event.
The Fire Supervision Restore Event is part
of Fire Events in Routing. If Fire Supervision
Restore Events are needed, simply enable
them in Routing.
Early Ambush Timer
Default:
Selection:
The programmed time is the maximum value of the
Early Ambush Timer. When Early Ambush is set to
Yes for a specified area (refer to A# Early Ambush on
page 42) and the area is disarmed, the user has the
amount of time programmed here to enter a second
code into the keypad.
No
Yes or No
Forces the Summary Fire relay
output to remain on after the Alarm
Silence command.
Allows Summary Fire relay output
to be silent when the Fire Alarm Bell
output is silenced and all Fire Points
return to normal.
0
0, 1, 2
The control panel sends a FIRE
TROUBLE RESTORE when a Fire
Supervision point restores to normal.
The control panel sends a FIRE
ALARM RESTORE when a Fire
Supervision point restores to normal.
The control panel sends a FIRE
SUPERVISION RESTORE when a
Fire Supervision point restores to
normal.
10 min
5 to 30 min
EN | 123