Auxparm; Introduction; Rps Requirements; Sdi Automation - Bosch D7212GV3 Program Entry Manual

D7212GV3 | Program Entry Guide | 6.0

6.0 AUXPARM

6.1

Introduction

The programming prompts in this section are
primarily used for programming Enhanced
Communication capabilities for the GV3 Control
Panels.
Enhanced communications represents the ability to
provide communication functions for the control
panels over the SDI. These communication methods
include:

Routing control panel events through a
network interface module (NIM).

A network interface module (NIM) can be an
ITS-DX4020-G or a DX4020.

Communicating with remote programming
software (RPS) using a (NIM).

Communicating with a remote or local
automation software package.
6.2

RPS Requirements

This AUXPARM section currently has six sections:


SDI Automation


SDI RPS Parameters

Enhanced Communications

SDI RPS/Enhanced Communication
Configuration

Miscellaneous

Cross Point Parameters

Route Group Parameters
Bosch Security Systems, Inc. | 10/11 | F01U170808-02
AUXPARM
6.3 SDI Automation
SDI automation defines the characteristics of a serial
interface module (SIM) when used with home or
business automation software. The SIM is a two-way
SDI to serial communication module that allows the
control panels to send and receive information to and
from an external software program.
The SIM can be a D9133, DX4010i, or
DX4020 (configured to emulate serial
communication).
UL requires that the DX4010i be used for
programming only.
This automation protocol allows external software
programs to interact and perform functions such as:

arming and disarming areas,

changing user passcodes and names, and

turning relays on and off.
The items described in this section allow some
simple configuration options. To receive the SIM
automation protocol; however, you must contact
Bosch Security Systems, Inc. Technical Support at
(888) 886-6189.
Enable SDI Auto
Default:
Selection:
Yes
No
Changing this item to Yes enables the automation
address (SDI Address 80).
No
Yes or No
Enable Automation software.
Disable Automation software.
EN | 111