Table 10: Diagnostic Reports; Table 11: Relay Reports - Bosch D7212GV3 Program Entry Manual

D7212GV3 | Program Entry Guide | 2.0
Diagnostic Reports
Selecting Yes enables sending a report when the
event occurs. If the off-normal state of any events
indicated by footnote 1 in Table 10 still exists, the
events report when a Test Report is enabled and
Expanded Test Report is programmed Yes. Refer to
the Test Reports sub-prompt in Section 2.3.8
Communication Attempts on page 14.

Table 10: Diagnostic Reports

Report
1
R# SDI Dev Fail
R# SDI Dev Restl
R# Watchdog
Rset
R#
ParaChksmFail
R# Reboot
1
R# Ph Line Fail
R# Ph Line Rstl
1
R# AC Fail
R# AC Restorl
1
R# Batt Missing
1
R# Battery Low
R# Battery Rstl
R# Rt Comm
1, 2
Fail
R# Rt Comm Rstl
Bosch Security Systems, Inc. | 10/11 | F01U170808-02
Selections Report
Description
Yes, No SDI device
failure
Yes, No Restoral of SDI
device failure
Yes, No Watchdog
Reset Event
Yes, No Parameter
checksum
failure
Yes, No Reboot Event
Yes, No Failure of phone
line
Yes, No Restoral of
phone line after
failure
Yes, No
Failure of AC
power to control
panel
Yes, No Restoral of AC
power to control
panel after
failure
Yes, No Battery Missing
Detection Event
Yes, No Low battery
power
Yes, No Restoral of
battery power to
control panel
after Missing or
Low Event
Yes, No Failure to send
report to specific
route
Yes, No Restoral of
communication
to specific route
after a failure
Panel and Area Wide Parameters
Table 10: Diagnostic Reports (continued)
R# Checksum Fail
R# Network Fail
R# Network Rest
R# Network Cond
1
This event is included in the Expanded Test Report
when an off-normal condition exists.
2
This event covers Comm Fail Route Group and Comm
Fail Phone. If enabled, both events are sent; if
disabled, neither event is sent.
3
This event is reserved for future use.
Enable Rt Comm Fail and Rt Comm
Restore in only one route group.
Relay Reports
Selecting Yes enables sending a report when the
event occurs.

Table 11: Relay Reports

Report
R# Sensor
Reset
R# Relay Set
R# Relay
Reset
When activating an on-board relay using
remote automation software, the
D7212GV3 Control Panel logs and prints
the event as:
Yes, No Checksum Fail
Event
3
Yes, No Failure of
network
3
Yes, No
Restoral of
network
3
Yes, No Condition of
network
Selections
Report
Description
Yes, No Sensor Reset
Event
Yes, No Relay Set Event
Yes, No Relay Reset Event
Relay 250 Relay A
Relay 251 Relay B
Relay 252 Relay C
EN | 19