Access Control Levels; Sia Duress Passcode Options - Bosch D7212GV3 Program Entry Manual

D7212GV3 | Program Entry Guide | 2.0
L## Restricted O/C
Default: Refer to the program record sheet
Selection: - or E
Generates an Opening Report if a bell is ringing or a
Closing Report when force or bypass arming. The
area where this authority level is assigned must be
programmed for restricted openings and closings
(refer to the A# Restrictd O/C prompt in Section
2.8.4 Open/Close Options on page 37.
L## Perimeter O/C
Default: Refer to the program record sheet
Selection: - or E
Generates Perimeter Opening and Closing Reports if
the area where this authority level is assigned sends
Perimeter Opening and Closing Reports. Refer to the
A# Perimeter O/C prompt on page 41.
L## Send Duress
Default: Refer to the program record sheet
Selection: - or E
Generates a Duress Report if the area where this
authority level is assigned sends duress. Refer to the
A# Duress Enable prompt on page 33.
L## Passcode Arm
Default: Refer to the program record sheet
Selection: - or E
Arm an area by entering a passcode and pressing
[ENTER].
L## Passcode Disarm
Default: Refer to the program record sheet
Selection: - or E
Disarm an area by entering a passcode and pressing
[ENTER].

2.10.8 Access Control Levels

L## Security Level
Default: Refer to the program record sheet
Selection: M, P, D, or -
This feature is not available with the D7212GV3.
Keep the default setting.
Bosch Security Systems, Inc. | 10/11 | F01U170808-02
Panel and Area Wide Parameters
L## Disarm Level
Default:
Selection:
This feature is not available with the D7212GV3.
Keep the default setting.
L## Function Level
Default:
Selection:
This feature is not available with the D7212GV3.
Keep the default setting.

2.10.9 SIA Duress Passcode Options

USER INTERFACE Authority Levels L## Disarm
USER INTERFACE Authority Levels L## Send
Duress
USER INTERFACE Authority Levels L##
Passcode Disarm
General Programming Information
User Authority Index 14 is programmed by default as
a duress disarm profile. When Duress Option is
configured with a value of 3, the SIA CP-01 compliant
Duress Passcode feature is enabled. With Authority
Index 14 assigned to a user passcode in an area,
that user has the authority to disarm and send a
duress event from that area.
A Duress Disarm user authority index requires:

L## Disarm set to E

L## Send Duress set to E

L## Passcode Disarm set to E
For SIA CP-01 Compliance
Duress Types 1 and 2 (refer to Duress Type on page
30) are not allowed for use in SIA CP-01 compliant
installations. All duress-capable passcodes must be
unique and cannot be derived from other passcodes.
To facilitate this uniqueness, user Authority Index 14
is preprogrammed from the factory as an example of
duress disarm authority.
Refer to the program record sheet
I, D, or -
Refer to the program record sheet
M, D, C, or -
EN | 68