Custom Functions; Configuration Authority - Bosch D7212GV3 Program Entry Manual

D7212GV3 | Program Entry Guide | 2.0
Display Rev
Default: E
Selection:
-, E, or P
Function Function Name
No.
32 Display Software
Revision
Use this function to show the control panel's software
revision number in the keypad display.
Service Walk
Default: P
Selection:
-, E, or P
Function Function Name
No.
33 Service Walk
Test
Use this function to Walk Test all 40 points in the
entire control panel regardless of the P## Type.
The Service Walk Test function must be
enabled in the Function List to access the
Service Walk Test.
Default Text
Default: P
Selection:
-, E, or P
Function Function Name
No.
34 Default Text
Determining the armed state of an area using the
programmed custom text might be difficult. Use this
function to switch temporarily to the control panel
default text, shown on the program record sheet.
Change Skeds
Default: P
Selection:
-, E, or P
Function Function Name
No.
35 Change Skeds
Execute this panel-wide function from any keypad
assigned to an area where the user has authority.
Use this function to change the S## Time from the
keypad to make adjustments to Skeds.
Bosch Security Systems, Inc. | 10/11 | F01U170808-02
Panel and Area Wide Parameters
Walk Test
Alternate
Keystroke
[COMMAND][5][9]
This function allows a user with the L## Invisible
Walk Test authority to test invisible interior or
perimeter controlled points that are within the scope
of the keypad, without sending reports to the central
station. Invisible points must have the P## Invisible
Point function programmed Yes.

2.10.4 Custom Functions

C Function 128 [through 131]
Alternate
Keystroke
(Menu function
only)
When enabled, Custom Function determines if a
passcode is required when accessing a custom
function from the menu list. ENTER PASSCODE (or
Enter Passcode + Enter Key on the D1260) appears
when this function is passcode protected. If a
command within the Custom Function is passcode
protected, the keypad displays ENTER PASSCODE
Alternate
(or Enter Passcode + Enter Key on the D1260) and
Keystroke
waits for the user to enter a valid passcode before
[COMMAND][5][7]
proceeding with the rest of the Custom Function. If a
passcode is not entered within 10 sec, the Custom
Function times out and the display returns to idle text.

2.10.5 Configuration Authority

Keypad Programming
Alternate
Keystroke
[COMMAND][5][2]
Use this function to make system programming
changes. When enabled, only the Service User
(Authority Level 15) has authority to access this
menu. When disabled (set to -), the programming
menu cannot be accessed through the Service User
menu.
Default: P
Selection:
-, E, or P
Function Function Name
No.
36 Invisible Walk
Test
Default: E
Selection:
-, E, or P
Function Function Name
No.
128 through Enable Custom
131 Functions 128
through 131
Default: P
Selection: - or P
Function Function Name
No.
N/A
Keypad
Programming
EN | 60
Alternate
Keystroke
(Menu function
only)
Alternate
Keystroke
(Menu function
only)
Alternate
Keystroke
Service Menu only