Table 4: D6000 User Ids And Zones - Bosch D7212GV3 Program Entry Manual

D7212GV3 | Program Entry Guide | 2.0

Table 4: D6000 User IDs and Zones

User ID Zone
Number
1 B
2 C
3 D
4 E
5 F
6 6
7 7
8 8
91 1
92 2
93 3
94 4
95 5
96 0
DTMF Dialing
Default: Yes
Selection:
Yes or No
Yes Dials the programmed phone
number(s) using DTMF.
No Pulse dialing only.
Use dual-tone multi-frequency (DTMF) to dial the
central station receiver phone number(s) for event
reports, or to dial the remote programming software
(RPS).
Phone Supv Time
Default: 0
Selection:
0, 10 to 240
0 No phone line supervision.
10 to 240 Enter the number of seconds (in 10
sec increments) you wish to wait
before indicating trouble. After a
faulted phone line restores, it takes
the same amount of time to start
restoral responses.
Phone line trouble responses: Keypads display
SERVC PH LINE # to indicate which phone line
failed. The keypad initiates a trouble tone if Buzz on
Fail is Yes and CC Trouble Tone is Yes.
Phone, Trouble, and Restoral Events report when
they occur. They report also when a Diagnostic
Report is initiated from a keypad or by a Sked.
Bosch Security Systems, Inc. | 10/11 | F01U170808-02
Panel and Area Wide Parameters
Alarm On Fail
Default:
Selection:
Yes
No
Phone Supv Time must be programmed
to use this feature.
Phone Failure Alarm Responses: The Alarm Bell
relay for Area 1 activates. All Phone Event messages
report as Area 1 and the account number for Area 1.
Buzz on Fail
Default:
Selection:
Yes
No
Phone Supv Time must be programmed
to use this feature.
When Buzz on Fail is Yes, users can disable the
resulting trouble tone on individual keypads by setting
CC# Trouble Tone to No.
Two Phone Lines
The D7212GV3 does not support the use
of the D928 Dual Phone Line Switcher.
Leave this prompt set to its default value.
No
Yes or No
Generate alarm responses when a
phone line fails.
Phone failures report as trouble
responses for Area 1 or the account
number associated with Area 1.
No
Yes or No
Generate panel-wide trouble tones
and display PHONE FAIL # at
keypads when a Phone Fail Event
occurs.
Does not generate trouble tones at
keypads when a Phone Fail Event
occurs. PHONE FAIL # still displays.
EN | 11