Setting Up Points And Outputs; Using The Relay Option Within Point Assignments - Bosch D9412GV4 Quick Reference Manual

Control Panel
7

Setting Up Points and Outputs

7.1

Using the Relay Option Within Point Assignments

Relay Programming allows any one point or several points to latch a single relay through
software when the selected point generates an alarm. Relays are number 1 through 8 and are
programmed by entering the number of the relay (1 - 8) in the Relay column in Point
Assignments. This relay latches on a generated alarm and resets after acknowledging and then
clearing the alarm from memory.
Relay
1
2
3
4
5
6
7
8
1 For the D7412GV4, connect to Terminal 28 for data (Zonex 1 Out)
For the D9412GV4, connect to Terminal 26 for data (Zonex 2 Out).
2
Table 7.1: Actual Relays Latched by Control Panel Type
Switch Number
1
2
3
4
Table 7.2: D8129 Switch Settings for All Control Panel Types
Notice!
Programmers must be aware of the following considerations:
Do not use relays designated within Point Assignments for multiple functions. For example,
Relays 73 through 80 on the D9412GV4 should not be used for relay-follow-point or area-wide
or panel-wide relays.
Relays should not be selected to follow points programmed as Invisible Points.
Bosch Security Systems, Inc.
D7412GV4
1
9
10
11
12
13
14
15
16
Setting
ON
OFF
ON
ON
Quick Reference Guide
Setting Up Points and Outputs | en
D8129 Actual Relay Number
D9412GV4
73
74
75
76
77
78
79
80
17
2
2014.05 | 05 | F.01U.265.463