Table of Contents
Advertisement
3.
Top feed
3.1
Position of the needle holder with single needle sewing machines
Rule:
The position of the needle holder is to be set according to the picture.
Angular position of
the needle holder
Needle thickness/Nm
1
5
4
6
–
Remove the thread guide (1).
–
Loosen screw (2) and turn the needle bar with the right groove
edge (3) to the needle bar axis (in sewing direction) and tighten
screw (2).
–
Bring the needle bar to the upper dead center and loosen the
screw of the needle holder through the bore (4) by using an Allen
key of 2.5 mm (5).
–
Turn the needle holder (6) according to the rule and tighten the
screw.
3
70 - 110
2
EN
17
Advertisement
Table of Contents
