Dürkopp Adler 550-867 Operating Instruction page 74

72
2. Confirm with OK.
3. Sew the end label into a free seam section.
 The next sewing process can be started when the seam
record set was completed without errors.
Faulty sewing process
If the sewing label is not scanned or failed to be detected by the
end label scanner, the following reminder will be displayed after
a preset number of stitches in the last seam section ( p. 115):
Fig. 57: Sewing in the end label (1)
1. Confirm with OK.
2. 2 options:
• Scan the end label barcode, sew the end label and
complete the sewing process.
OR
• Complete the sewing process without sewing in the end
label because, for instance, the end label is damaged and
the end label barcode can no longer be scanned.
 An error message is displayed.
Users with security level 0 will only be able to cancel the
sewing process from here on. The sewing material in this
case is faulty and not suitable for use.
3. Log in with security level 1 or 2 ( p. 88).
 The display switches to:
Operating Instructions 550-867 - 00.0 - 11/2016
Operation