Dürkopp Adler 550-867 Operating Instruction page 31

Operation
Operating Instructions 550-867 - 00.0 - 11/2016
Fig. 13: Feeding needle and hook thread (2)
④
⑤
(4) - Needle/hook thread barcode
(5) - Barcode scanner
(for the barcodes of needle
and hook thread)
Needle and hook thread are each fed from the reel stand to the
tensioning plate (needle thread) / the winder (hook thread).
To feed the needle/hook thread through the hose guide:
1. Loosen the ball (3).
2. Remove the washer (2).
3. On a machine without a barcode scanner (5) for the needle/
hook thread:
Use the hand scanner to scan the needle/hook thread barcode.
Fit the thread reel (1) on a thread reel holder (6).
On a machine with a barcode scanner (5) for the needle/hook
thread (optional,  p. 63):
Fit the thread reel (1) on a thread reel holder (6).
Make sure that the needle/hook thread barcode (4) can be
scanned by the barcode scanner (5).
Information
If the needle/hook thread barcode (4) is not detected by the
barcode scanner (5), a message will appear on the control panel.
If this happens, align the thread reel (1) anew and scan the needle/
hook thread barcode (4) again.
(6) - Thread reel holder
⑥
29